{Stus-List} Bow Anchor Roller

dwight veinot dwightveinot at hfx.eastlink.ca
Sat Sep 3 07:44:46 EDT 2011


Jim

 

You could drill a hole through the anchor so you could use a pin to hold it
secure on the roller.I had to do that with my Bruce anchor but I also attach
a line secure to the boat at the chain end with a snap shackle

 

D. Veinot

C&C 35 MKII, Alianna

Head of St. Margaret's Bay, NS

  _____  

From: cnc-list-bounces at cnc-list.com [mailto:cnc-list-bounces at cnc-list.com]
On Behalf Of Jim Watts
Sent: September 2, 2011 10:26 PM
To: cnc-list at cnc-list.com
Subject: Re: {Stus-List} Bow Anchor Roller

 

Here's my minimalist setup. A little more projection wouldn't hurt (notice
the dings in the glass from letting the windlass bring the anchor up the
last 3 feet), and more width so I don't have to use a really skinny
expensive and prone to failure stainless swivel. Apart from that, it works
just fine. The holes in the cheeks were originally placed for another
anchor, but I use them now to take a Faspin to keep the chain from jumping
off when the hook is down. 

 

http://members.shaw.ca/paradigmshift/images/roller.jpg

 

 

Jim Watts
Paradigm Shift
C&C 35 Mk III

  _____  

No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1392 / Virus Database: 1520/3874 - Release Date: 09/03/11

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://cnc-list.com/pipermail/cnc-list_cnc-list.com/attachments/20110903/480c8e18/attachment-0002.html>


More information about the CnC-List mailing list