Stus-List 33-2 shroud tensions

robert robertabbott at eastlink.ca
Thu May 18 10:02:51 EDT 2017


Mike:

The Loos RT 10 gauge can measure the diameter of the rod.

Rob

On 2017-05-18 10:19 AM, Hoyt, Mike via CnC-List wrote:
>
> Does anyone know off hand the diameter of the rod used on 33-2 
> upper/lower/intermediates?
>
> *From:*CnC-List [mailto:cnc-list-bounces at cnc-list.com] *On Behalf Of 
> *John McKay via CnC-List
> *Sent:* Thursday, May 18, 2017 10:16 AM
> *To:* cnc-list at cnc-list.com
> *Cc:* John McKay
> *Subject:* Re: Stus-List 33-2 shroud tensions
>
> Mike
>
> The guage will give a recommended tension for the rod diameter. I 
> would started with this.
>
> I just started to use the Loos guage last fall so not much experience 
> with the guage really.
>
> John on Enterprise
>
> Sarnia Ontario
>
> On Thursday, May 18, 2017 8:19 AM, "Hoyt, Mike via CnC-List" 
> <cnc-list at cnc-list.com <mailto:cnc-list at cnc-list.com>> wrote:
>
> Does anybody have numbers for shroud tension on 33-2 using Loos Rt-10?
>
> Thanks
>
> Mike
>
> For Colmonel
>
> _______________________________________________
>
> This list is supported by the generous donations of our members. If 
> you wish to make a contribution to offset our costs, please go to: 
> https://www.paypal.me/stumurray
>
> All Contributions are greatly appreciated!
>
>
>
> _______________________________________________
>
> This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to:  https://www.paypal.me/stumurray
>
> All Contributions are greatly appreciated!

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://cnc-list.com/pipermail/cnc-list_cnc-list.com/attachments/20170518/0a7c1d9a/attachment-0002.html>


More information about the CnC-List mailing list