Stus-List Straightening Stanchions...

CHARLES SCHEAFFER cscheaffer at comcast.net
Tue May 21 09:47:44 EDT 2019


Hi David,
I straightened two of my stanchions using gentle persuasion.
I think I used a piece of pipe over the outside and clamped the pipe into a bench vise.
Then I slipped the stanchion into the pipe and using another longer section of pipe, hand bent the thing straight.

Chuck S


> On May 21, 2019 at 8:00 AM David Risch via CnC-List <cnc-list at cnc-list.com> wrote:
> 
> 
>     Hello,
> 
>      
> 
>     A few of my stanchions on my 1981  are not as straight as I would like due to years of use and the yard shrink-wrapping around them to the deck.  Anyone try to straighten theirs?  I understanding cold bending S/S is  not too fatiguing within reason…although they are stanchions and any fatigue might be detrimental. 
> 
>      
> 
>     Thanks in advance.
> 
>      
> 
>      
> 
>     David F. Risch
> 
>     Gulf Stream Associates
> 
>     (401) 419-4650
> 
>      
> 
>      
> 
>      
> 
>      
> 
 

> _______________________________________________
> 
>     Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
> 
> 
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://cnc-list.com/pipermail/cnc-list_cnc-list.com/attachments/20190521/94208869/attachment.html>


More information about the CnC-List mailing list